Olimpia splendid Bi2 WALL TR 1000, Instructions For Use And Maintenance Manual

Page: 72 / 449

EN - 24
ENGLISH
- Enable Autonomous configuration (paragraph “5.4”, configuration parameter
“ CF ”).
- Set the protocol type ASCII if SIOS CONTROL envisages B0863 or RTU if SIOS
CONTROL does not envisage B0863 (paragraph “5.4”, configuration parameter
“ bU ”).
- Set the address, each appliance must have an address different from all the
other units connected to the same BUS (paragraph “5.4”, configuration parameter
“ Ad ”).
- As regards mounting of the connections, proceed by following the indications
described in the previous paragraphs.
Once the operations have been completed, reposition the previously disassembled
parts, taking care to connect the display connector and the earth connection cable.
Secure the front shell through the 6 screws, then feed the machine.
• When the unit is configured for remote control, the remote con -
troller is disabled.
• It is not possible to control the flap from remote control.
• In this mode, the air probe installed on board the fan coil is ig -
nored.
5.4 - BOARD SOFTWARE CONFIGURATION
Work as follows:
a.
Connect power supply, then ensure that the latter is set to any mode except for stand-by.
b. On the control panel, simultaneously press the key “ ” (T2) and “ ” (T1) for
at least 5 seconds, until an acoustic signal is emitted.
c. The display shows the reference to the parameter
d. Scroll using the key “ ” or “ ” (T1) until you select the desired parameter
e.
Press the key “ ” or “ ” (T1) to scroll the list of parameters: CF -> bU -> Ad
-> Fa -> Po -> co -> CF -> …
f. Press key “ ” (T2) to access the value
g. Release and press key “ ” (T2) for more than 3 seconds to change the value
(Display blinking)
h.
Press key “ ” or “ ” (T1) to scroll the possible values of the parameters
i. Press key “ ” (T3) to confirm the value
j. Press key “ ” (T3) to exit the configuration or wait 20 seconds.
Quit and give power voltage to the system to start the unit under
the new configuration.