INSTALLATION INSTRUCTIONS
ATTENTION!!!
During installation follow this light
direction.
Corridor
lighting
Open
area
lighting
1
2
Cable
entry
hole
3
N
L
923473000_0
9
_00
1
Initial installation
1
.
Detach the front cover by applying pressure using a flat blade screw driver. Next, unfasten the
four retaining screws without removing them and remove the diffusor.
2.
Install the battery connector to its corresponding connector on the main pcb.
3
.
Use a cable with a round cross-section and a diameter of
5-10
mm (type
H05RN-F 2x1mm²
or equivalent).
WARNING!
!
The cable must not be deformed in any way in order to preserve the IP rating
).
Install the cable grommet in the open hole of the plastic base and open a hole in the center of the
grommet using a small screw driver
.
Pass the power cable through the hole in the grommet
(
If required, open another cutout cable
entry hole and install the second supplied cable grommet
).
Connect the cables as shown in the
photograph.
Use the supplied self adhesive pad and cable tie to anchor the cable.
4
.
Reinstall the diffusor and re-tighten the 4 screws in a diagonally manner with a torque of
0,9
N*m
.
NOTE!! After finishing the installation you must power the luminaire for at least 24 hours in
order to completely charge the batteries. The rated autonomous duration can be achieved
after this.
GR-
470
/WP, GR-
472
/WP
GR-
4
71/WP, GR-
4
73/WP
Page
2 from 6
