OLI NO-TOUCH, User Manual

Page: 15 / 60

15
EN
RU
DE
12-TROUBLESHOOTING
MALFUNCTION POSSIBLE CAUSE PROCEDURE
Flush plate flashes red after flushing • Low energy level • Recharge battery
Flush plate flashes red and doesn’t flush
• Extremely low energy level • Recharge battery
• Faulty mechanism • Replace flush mechanism
• Obstructed servomotor
• Check the flush mechanism (outlet
valve) configuration
Frequent low battery (red flashes) indication
• Clogged filter • Verify/clean the filter
• Faulty hydro generator • Replace hydro generator
When interacting with the flush plate, lighting works
but no flush is performed
• Faulty software • Reboot system
• Servomotor misconnection • Check connections
• Faulty servomotor • Replace servomotor
• Empty cistern
• Check angle valve
• Check for eventual blocking in the
filling mechanism (inlet valve)
• Check for water in the grid
When interacting with the flush plate, lighting doesn’t
work but a flush is performed
• Faulty software • Reboot system
• LED function deactivated • Check LED function setting
When interacting with the flush plate, lighting doesn’t
work and no flush is performed
• Faulty software • Restart system
• Drained battery • Recharge battery
• Misconnections
• Check connection with hydro
generator
• Faulty hydro generator • Replace hydrogenate
• Poor calibration • Reboot system
• Faulty sensor • Replace sensor / flush plate
When interacting with the flush plate, two flashes in
both sensors are presented and no flush is performed
• Cleaning mode activated due to poor
calibration
• Reboot system
• Excessive condensation inside the flush plate • Verify / clean flush plate interior
Ceramic bowl cleaning is not effective • Flush volumes may be set incorrectly
• Check the flush mechanism (outlet
valve) configuration
• Check if the filling mechanism (inlet
valve) is performing correctly
Water runs continuously in ceramic bowl
• Faulty software • Reboot system
• Faulty rubber sealing • Replace rubber sealing
• Faulty flush system • Replace flush system
• Faulty filling mechanism (inlet valve) • Replace filling mechanism (inlet valve)
Unprovoked flushes
• Hygienic automatic flush activated
• Verify hygienic automatic flush
function setting
• Poor calibration • Reboot system
Incorrect flushes
• Faulty software • Reboot system
• Dirty or wet flush plate • Verify / clean flush plate interior
• Poor calibration • Reboot system
Charger doesn’t show green light
• Faulty wall charger • Replace the wall charger
• Faulty hydro generator • Replace hydro generator