Oleo-Mac efco BLE 506, Operators Instruction Book, Page: 51 / 406

51
5.5.4 TRAVELLING ON A SLOPE
This riding mower may work on slopes with an incline of up to 12° (21%) ,
when 4x4 drive is used, the slope incline must to be greater than 15° (27%) .
When working on a slope it is necessary to adhere to the following
fundamentals:
►
Pay increased attention when travelling on a slope.
►
Always use a slower travelling speed.
►
Only travel perpendicular to the contour, i.e. up and down. Travelling in the
direction of the contour is possible with extra attention only when turning
the mower. If at all possible, avoid travelling along the contour.
►
When turning ensure that a wheel does not drive over an elevated obstacle
(rock, tree root, etc.)
►
Travel slower when travelling down a slope or over obstacles. Pay special
attention when turning and turning around on slopes.
►
If you stop on a slope, always use the parking brake.
Correct
105J / 106 / 124:
106 4x4:
o Max 12 (21%)
o
Max 15 (27%)
Wrong
When overloading the mower by travelling on slopes over the aforementioned values, there is a risk of serious damage to the
transmission. The manufacturer is not responsible for damage caused in this way.
5.6 EMPTYING THE GRASS CATCHER
The full level of the grass catcher is signalled by the full grass catcher flap. It is possible to regulated the full level of the
grass catcher by moving the sliding part of the flap (extending or shortening the arm) and thereby optimise its filling up
for various types of collected vegetation (dry grass, wet grass, leaves, etc.).
(1) Sliding part extended = grass catcher filled to minimum
(2) Sliding part retracted = grass catcher filled to maximum
5.6a
Procedure for emptying:
►
Drive the mower to the location where you wish to empty the grass catcher. Stop the mower and apply the brake. If on a slope,
use the parking brake.
►
Disengage the mowing deck by pushing down the engagement switch.
►
If the AUT/MAN switch is installed on the mower, leave this switch in position " AUT ".
►
Set the throttle lever to position " MIN ".
►
Slide the grass catcher dump lever handle completely upwards (1) and tilt it down (2) to tip out the grass catcher,
allow it to empty freely, slowly release it and tilt it back.
5.6b