WX16 User Manual | 60
Figure 7.2
7.2
Wireless Receiver Mode
Wireless Receiver
mode is exclusively for wireless communication to Oldham’s OLCT
200 wireless sensor transmitters (See
www.oldhamgas.com
for more details). In
Receiver mode, the radio connects to the WX16’s
master
port and receives input data
from up to sixteen OLCT 200 sensor transmitters. Wired and wireless inputs may be
mixed between the WX16’s sixteen channels, so it is possible to also accept wired
signals from analog input option PCB’s described in section 3.1.
Use the
WIRELESS RF900
setting shown at center of Figure 7.3 ONLY FOR
COMMUNICATION TO OLCT 200 WIRELESS TRANSCEIVERS. See section 7.4 for
setting up wireless networks with other ModBus slave devices.
OLCT 200’s transmit 200 counts for 0% and 1000 counts for 100% full scale readings
so
Input Min/Max
menu values should be 200 & 1000. The
Remote ID
menu entry
must match the
Remote ID
address setting in the OLCT 200 providing data to this
WX16 channel.
Input Req
is typically set to VALUE but also allows a BATT entry into
this field. Entering BATT causes the channel to display (and alarm) from battery
voltage levels at this OLCT 200. Voltage level of the 3.6 volt lithium battery in this
OLCT 200 is also displayed on this screen.
Figure 7.3
Summary of Contents for WX16
