Okina USA HD5FE-8012, User Manual

Page: 8 / 16

8
PATTERN Submenu
PATTERN MODE1 Camera 1+360
∘
MODE2 Camera 2+360
∘
MODE3 Camera 3+360
∘
MODE4 Camera 4+360
∘
MODE5
Quad+360
∘
MODE6
Camera 1+Camera 3+360
∘
MODE7 See below for more details
MODE8 180° in 16 :9 Display
MODE9 360° Flat
MODE10 180
∘
+Camera 3+Camera 4
MODE11 180
∘
+ 180
∘
MODE12 Quad display only
MODE13 360° display only
When you change the pattern mode, you have to wait 10 sec until it change to selected mode. If you want to
immediately see the mode please press the Enter button.
Pattern Mode 7
In this mode user can choose among 4 different angle view, each can have horizontal and vertical flexibility
range.
View available 120° 140° 160° 180°
Verticale range D : 0~5
U : 0~5 D : 0~4
U : 0~4 D : 0~3
U : 0~3 D : 0~2
U : 0~2
Horizontal range L : 0~5
R : 0~5 L : 0~3
R : 0~3 L : 0~1
R : 0~1
0
SYSTEM Submenu
SYSTEM
CAMERA1 ON/OFF
CAMERA2 ON/OFF
CAMERA3 ON/OFF
CAMERA4 ON/OFF
AUTOFLIP ON/OFF
SETID
If user plans to have more than 1 device in the
installation
LOAD DEFAULT Will reset the device to factory default
RETURN
SET ID
This function is very useful if you plan to install more than one panoramic camera on site
You need to set ID on each camera by using the built in keypad, please don’t set same ID on 2 camera,
otherwise the control keyboard will call them together
For example if you set ID of the first camera to 1, and the ID of the second camera to 2, when you use the
control keyboard you can call any camera from 1 to 8. The below table gives you the camera number
SETID CAMERA1 CAMERA2 CAMERA3 CAMERA4 OSD (displayed
next to firmware
version)
0 CAMERA1 CAMERA2 CAMERA3 CAMERA4 Nothing (Single
device)
1 CAMERA1 CAMERA2 CAMERA3 CAMERA4 SETID 01 (multi
device)
2 CAMERA5 CAMERA6 CAMERA7 CAMERA8 SETID 02 (multi
device)
. . . .
. . . .
. . . .
16 CAMERA61 CAMERA62 CAMERA63 CAMERA64 SETID 16 (multi
device)