OKIDATA OF1050, Service Manual

Page: 436 / 449

6) Remove three screws 9 which are holding the guide R (2nd) assy 0 to the bottom plate A. Remove the
screw B which is keeping the rear cover C and guide R (2nd) assy 0. Remove the guide R (2nd) assy 0.
7) Remove the protect (M) D, guide bracket E, planet gears F and planet gear bracket G.
8) Remove the E-ring H which is keeping the sheet link I on the guide R (2nd) assy 0, and pull out the
hinge stand J.
9) Remove three remaining screws K which are keeping the motor on the motor bracket L, and remove
the connector off the motor M.
10) Remove two screws N on the motor M.