OKIDATA Microline ML395, Handbook

Page: 44 / 79

up to the tear bar: you must press the SELECT button to put the printer back on-line before it will move
the paper back down.
Graphics.
Bi-directional graphics print faster than uni-directional graphics, but uni-directional graphics have better
print registration. Bi-directional graphics printing can be optimized by adjusting the Print Registration
setting in the Menu.
Language Set.
American (factory default), French, German, British, Danish I, Swedish, Italian, Spanish I, Japanese,
Norwegian, Danish II, Spanish II, Latin American, French Canadian, Dutch, or Publisher. Replaces
certain symbols with special characters used in the respective foreign languages.
Line Spacing. Choose 8 lines per inch for tighter line spacing, to get more lines per page. This item is
set separately for each paper path.
Max. Receive Buffer.
Choose 1 line, 8K (factory default), or 23K. Selects the amount of memory devoted to holding re-ceived
data. Choosing 1 line will tie up your computer during printing, but if you abort the print job the printer will
stop printing much sooner.
Menu Line.
Sets number of lines skipped down after each line prints when you are making changes in the Menu.
Switch to 1 if you want to conserve paper when making changes in the Menu.
Operator Panel Function.
Change to Limited Operation to deactivate the FONT, PRINT QUALITY and CHARACTER PITCH
buttons on the control panel so that you can control these features only through your software. This can
be useful when several people are using the printer and you dont want its settings changed.
Note This feature also prevents access to the Menu. To access the Menu, turn the printer off, then hold
down the QUIET key while turning on the printer.
Page Length.
12", 11" (factory default), 11-2/3, 14", 17", 3", 3.5", 4", 5.5", 6", 7", 8", 8.5". Set separately for each paper
path.
Page Width.
Choose a page width of 13.6" (factory default) or 8".Paper Out Override. The paper out detector senses
when less than an inch of paper remains in the printer and stops printing at that point. Changing this
setting to Yes overrides the detector so you can print closer to the bottom of the page if youre using
single sheets. Be careful if you use this feature: it lets the printer continue printing when theres no more
paper, which can cause loss of data and can damage the printhead.
Paper/Transparency.
Choose Paper (factory default) or Transparency as your print medium for Cut Sheet feed.
Parity (Serial Interface only).
None (factory default), Odd, or Even. Selects the type of parity your system uses.
Pitch.
10 cpi (factory default), 12 cpi, 15 cpi, 17.1 cpi, 20 cpi, or Proportional. Selects the character width
measured in characters per inch (cpi).
Print Mode.
Change to NLQ for slightly faster near-letter-quality printing; Utility for higher-speed printing with reduced
quality; HSD (High Speed Draft) for the fastest, but lowest quality printing.
Print Registration. Change the setting as required to obtain the best registration for bi-directional printing.
ML395 ( 96-02-07 )