Reactivity Data
Stability: Stable
Polymerization: Will not occur.
Hazardous Decomposition Products: Thermal decomposition
may result in release of oxides of carbon and nitrogen.
Temperature: Do not expose to temperatures above 200°C
(392°F).
Incompatibility: Avoid exposure to strong oxidizers.
Spill Cleanup and Disposal
Spill Cleanup
Small Spills
1 Remove sources of ignition.
2 Clean up spill with wet cloth.
Large Spills
1 Remove sources of ignition.
2 Wear protective gear: respirator, rubber gloves, goggles.
Refer to “Safe Handling and Use” in this MSDS.
3 Clean up spill with scoop, being careful not to generate a lot
of dust.
Waste Disposal
Follow appropriate federal, state and local regulations.
Safe Handling and Use
Respiratory Protection: Not normally required. For large spills,
use NIOSH-approved full face-piece respirator with HEPA
cartridge during cleanup.
Protective Gloves and/or Eye Protection: Not normally
required. For large spills, use rubber gloves and chemical
worker’s goggles during cleanup.
Ventilation: Outside of normal ventilation, not normally
required.
Other Protective Equipment and/or Hygienic Practices: None
Special Precautions
Precautions for Handling or Storage: Protect from high heat.
Avoid making dust.
Other Precautions: None
The information contained in this MSDS is based on data
considered accurate; however, no warranty is expressed or
implied regarding the accuracy of these data or the results to
be obtained from the use thereof. Vendor assumes no
responsibility for injury to vendee or third person party
proximately caused by the product if reasonable safety
procedures are not adhered to as stipulated in the MSDS.
Furthermore, vendor assumes no responsibility for injury to
vendee or third person party proximately caused by
abnormal use of the product even if reasonable safety
procedures are followed. Additionally, vendee assumes the
risk of his use of the product.
Safety Information
Installation Hints
•
Install your fax unit in a dust-free location away from direct
sunlight.
•
Do not plug your fax unit into a power source shared by
equipment which produces electrical noise (i.e., air
conditioners, etc.).
•
Leave electronic adjustments to authorized service personnel.
•
The LINE terminal connects your fax machine to a standard
telephone line. To avoid damage to your telephone system or
to the fax unit, do not plug your fax machine into anything
other than a standard RJ-11C jack.
•
Your fax unit is intended to be grounded electrically and is
equipped with a three-wire grounded power cord. For your
safety, do not attempt to defeat your power cord’s grounding
plug.
•
The power outlet should be located near the equipment and
should be easily accessible.
•
The TEL port on the back of the unit is only suitable for 2-
wire devices. Not all standard telephones will respond to
incoming ringing when connected to an extension socket.
•
This equipment may not necessarily provide for the effective
hand-over of a call from a telephone connected to the same
line.
Operation and Maintenance
•
Use a dry cloth to clean the control panel and the main body
of the unit.
•
Aside from replacing the toner and image drum cartridge, do
not disassemble or attempt to service this unit yourself. Refer
to a qualified technician for service. See “Service and
Support.”
•
Disconnect the power cord before trying to remove any
objects that may have fallen into the machine.
•
When relocating your fax unit, always disconnect the
telephone line before disconnecting the power cord. Always
reconnect the power cord first.
•
This unit is not intended to be used in parallel with any other
telephone devices.
•
If anything happens that indicates that the fax unit is not
working properly or has been damaged, unplug it
immediately. Follow the instructions in “Service and
Support” to have your fax unit serviced.
These are some of the things to look for:
•
The power cord or plug is frayed or damaged.
•
Liquid has been spilled into the printer, or it has been
exposed to water.
•
The fax unit has been dropped, or the cabinet is damaged.
•
The fax unit does not function properly when you’re
following the operating instructions.
