Oki MC361, Service & Troubleshooting Manual

Page: 28 / 59

3. The setting option and its setting appear on the upper and lower displays,
respectively. Pressing
[2]
displays the next setting and pressing
[8]
displays the
preceding setting (the setting last displayed is applied. Press
[4]
to accept the
setting and return to step 2. Repeat step 3 when necessary.
Display Setup Value Function
PRINT EXECUTE -
Starts’ printing with the press of
[6]
button, and ends
printing with the press of the
[#]
button.
TEST PATTERN 0
0: Prints a blank page.
1 to 7: - See the next section (pattern printing)
8 to 15: Each prints a blank page.
TRAY1
TRAY2
TEST CASSETTE
MPT Tray
Selects a paper source.
TRAY2 is not displayed when the tray 2 is not
installed.
PAGE 0000 Sets the number of test copies to print.
ON
COLOR
OFF
Selects color or monochrome printing.
* ON and OFF are provided for each color when the
setting ON is specified.
2 PAGES STACK Performs duplex printing using a two pages layout.
OFF Selects turning off duplex printing.
DUPLEX
1 PAGES STACK Performs duplex printing using a one page stack layout.
Default is in shaded areas (XXX). Set settings are enabled only in this test mode (not
written into the EEPROM)
Note
:
PAGE
: Moves its input digit with
[2]
or
[8]
. The setting for this option is incremented by
pressing the
[*]
button, and decremented by pressing the
[#]
button. Note that, when left
set
,
the setting 0000 endlessly prints pages.
COLOR
: When set to ON, with the press of the
[6]
button, displays the information
shown below.
Setting option for printing colors: Moves its input position with
[2]
or
[8]
. The setting for
each color is switched between ON and OFF by the press of the
[*]
or
[#]
button. The
panel display is restored to the previous one by pressing
[4]
.
4. With
PRINT EXECUTE
displayed on the lower display by the operation in step
2, pressing the
[6]
button executes test printing by using the setting(s) made in
steps 2 and 3.
The test printing is cancelled by pressing the
[#]
button.
When detected in starting or performing the test printing, an alarm shown in the
detail section of the following list is displayed on the operator panel, stopping the
printing.
28