7
disPenseR insTallaTion
To install the optional dispenser
1.
First, follow the instructions in the
Removal of the Bottom
housing Cover
section.
2.
Turn over the printer in upright position. Pull the
cover open/
close latches
on both sides of the printer toward you to
unlock the
Top cover
, and then open the
Top cover
. Remove
the
lower front cover
by pulling the bottom slightly away
from the printer and lifting it upward.
3.
Before installing the
dispenser kit
, open the
Pressure
bracket
by lifting upward and outward as shown.
4.
Attach the
latches
of the
dispenser kit
onto the
holes
located below the two sides of
platen roller
of the printer.
Close the
top cover
, close the
Pressure bracket
by pushing
it in until it locks into place, then turn the printer over again,
with the
main PCB
facing upward.
note: Be sure to keep the cable off to the side during
installation.
1
2
Pressure
bracket
Hole and latch
Summary of Contents for LD610 T
Page 39: ......
