10
disPenseR insTallaTion (ConTinued)
stop position adjustment
Normally, the label is dispensed to the point where 2 or 3mm (0.08" or 0.1") of the label remain on the liner
(backing paper).
If the label is not dispensed at the regular position, you can change the
offset setting
with the SBPL commands.
Please refer to the
offset Position adjustment section
for the detailed procedures. After adjusting the stop
position, dispense two or three labels to fix the stop position.
notes:
• There may be cases when the dispenser does not function properly due to the thickness of the labels used.
• The Dispenser unit is effective for label pitch 22 to 100 mm (0.86" to 3.93"). However, the label size limitation
may vary with application conditions.
• Labels over 100mm (3.9") may curl at dispenser due to the nature of the material. There is no remedy for this.
Summary of Contents for LD610 T
Page 39: ......
