3
Removal of The BoTTom housing CoveR
1.
Make sure the printer is powered off and disconnect the
power cable and interface cable.
2.
From the
base
of the printer, remove three
screws
(circled)
as shown.
CAUTION:
Ensure not to scrape the window portion when the
printer is turned over.
3.
Remove the
Bottom housing cover
.
Proceed to the next section(s) to install the desired option(s).
4.
Follow the above steps in reverse sequence to reassemble
the
Bottom housing cover
.
notes:
• Ensure the wiring route neatly as shown and arrange all
the wiring to avoid from being pinched when fitting the
bottom housing cover
.
• When reassemble the
Bottom housing cover
to the
printer with
ieee interface terminal
, flip one of the
clip
of the interface terminal as shown. Then fix the
Bottom
housing cover
while holding the other
clip
, pulling the
Bottom housing cover
forward and downward.
screw x 3
clip
Summary of Contents for LD610 T
Page 39: ......
