43827101TH Rev.2
156 /
Oki Data CONFIDENTIAL
• To specify a PU Serial Number, enter a 11-digit number prefixed with "0" (single-byte
zero). (Notice that, when the PU Serial Number is read, it is a 10-digit number.)
On the "PU Serial Number setup" screen, enter the 11-digit number resulting from
prefixing a single-byte zero to the 10-digit number which is obtained by excluding the
two digits for Revision, shown in the image diagram below, from the serial number on
the "PU Serial Number setup" screen.
[Other than for OEL]
[For OEL]
Figure of Serial No. label image
• The PU Serial Number is output in the Printer Serial Number field of the Menu Map
header section. For this reason, check of PU seriel Number is performed by printing
Menu Map.
• In the case of the OEL destination, the PU Serial Number is output, as a Lot Number, in
the Lot Number field in the bottom line of the Menu Map header section after the
configuration at the UK Plant. [See 1. (2) of Subsection 5.4.2.]
(2) Switching to Shipping mode
When the engine control PCB has been replaced with a new one, the printer still is in the
Factory Work mode. Switch it to the Shipping mode.
• Make the switching on the "Subsection 2.4.1.1.2.2 Factory/Shipping mode" screen in
"Subsection 2.4.1.1.2 PU PCB setup function" of the maintenance utility.
Figure of Serial No. label image (labeled in UK Factory)
Enter the 11-digit number resulting from prefixing "0" (single-byte zero) to the 10-digit number.
(Enter "0AE1234567.")
Revision
A
B
C
Made in
A E 0 1 2 3 4 5 6 7 8 9
Enter the 11-digit number resulting from appending "0" (sing-byte zero) to the left of the 10 digits of Lot Number
(Enter "0AE47027880.")
Revision
Ser.NO. 4AEL4011702K
Lot.NO. AE47027880 A0
Made in Thailand
Configured in UK