BMG7011 and BMG7012 User’s Guide Rev. 1.9
© Copyright, 2004 Oki Network Technologies. All Rights Reserved
5
2.3
Initial Installation Procedures for ADSL and Cable Networks
Prior to installing the BMG7011/7012 into the network, the units must be setup to work within either a PPPoE, DHCP,
or Static IP environment. This is accomplished prior to placement of the unit into the network.
1.
Configuring TCP/IP Protocol for your PC allowing for entry into web based setup screens
Steps involved with
configuring the BMG7011 and BMG7012 VoIP gateways in Supervisor Mode
2.
Setting your BMG to communicate through PPPoE
3.
Setting your BMG to communicate through DHCP
4.
Setting your BMG to communicate through a Static IP address
2.3.1
Configuring TCP/IP Protocol for Your PC
To communicate with and configure this device, you will need to set your PC ‘s IP protocol to the default BMG IP
Address. If you enable static IP addressing, make sure your PC resides in the same subnet with this device’s LAN IP
Address (default IP Address: 192.168.100.1, default subnet mask: 255.255.255.0).
For Windows 98/Me
1.
From the
Start
menu, click
Settings,
and then click
Control Panel
.
2.
Double-click
Network
.
3.
On the
Configuration
tab, check if TCP/IP protocol is installed on the components list.
4.
If yes, go to Step 8. If no, then click
Add
.
5.
Highlight
Protocol
and click
Add
.
6.
Select
Microsoft
from the Manufactures list and select
TCP/IP
from the Network Protocols list.
7.
Click
OK
. You will see
TCP/IP
displayed on the network components list.
8.
Highlight
TCP/IP
and click
Properties
.
9.
Select the
IP Address
tab and check
Specify an IP address
.
10.
Set
IP address
as 192.168.100.100,
Subnet mask
as 255.255.255.0 and press
OK
.
For Windows 2000/XP
1.
From the
Start
menu, click
Settings,
and then click
Network and Dial-up Connections
.
