11
EN
INSTALLATION
1
For installation pay attention to all dimensions. Prepare a cutout A x B mm into the work plate.
L (mm)
W (mm)
H (mm)
D (mm)
A (mm)
B (mm)
X - (mm)
590
520
55
51
564
494
50 (for rear side and for
only one side (left or right)
WARNING! Pay attention to the safety clearances to the side and rear. When installing a hob higher
cabinets or room walls are only allowed with a 60 mm distance from the rear and 55 mm distance
from only one side (right or left). There shall be no higher cabinet or wall to the other side (right or
left).
2
Consider the minimum clearances for air circulation inside the kitchen cabinet.
A (mm)
B (mm)
C (mm)
D
E
min. 760
min. 50
min. 20
Air inlet
Air outlet min. 5 mm
WARNING! If a hood is placed over the hob, the safety distance specified by the manufacturer must
be observed.
If no manufacturer's instructions are available or combustible materials (e.g. a wall unit) mounted
above the hob, the safety distance A must be at least 760 mm.
3
If possible connect the hob to the mains before installing the hob to the work plate.
WARNING! Before connecting, all poles of the corresponding circuit must be disconnected from
mains supply. Use suitable measurement equipment to make sure the circuit is disconnected from
mains supply.
The corresponding circuit shall be secured against unintentional reconnection.
The electrical connection must be done by an appropriately trained professional.
Note: If the mains cable is damaged and needs to be replaced, the replacement and electrical re-
connection must be done by an appropriately trained professional only.
1.
Remove the protective cap from the terminal.
2.
Pay attention to the connection diagram and connect L, N and ground to the terminal
accordingly. Make sure that all cables are firmly fixed.
3.
Put the protective cap back on the terminal.
• Pay attention to the connection diagram and connect L1, L2, N and ground to the terminal
accordingly. Make sure that all cables are firmly fixed.
4
Place the cooktop centered into the cutout of working plate. The sealing strip is already adhered to
the underside of the cooktop field. The edge of the working plate must be smooth and flat, so that
the hob seats solidly and the sealing strip provides sufficient seal between cooktop and working
plate.
Note:
If the working plate is not smooth, e.g. tiled you need to fill the gaps or joints in the support area of
the seal.
WARNING! Make sure the power cord is not kinked, squeezed or laid over sharp edges. The cable
must be guided to the connection so that it does not touch hot parts of the hob or oven.
5
Mount the four brackets with the screws (4 x brackets and 4 x screws included) from the bottom.
The brackets must be turned into correct position according to the thickness of the board.
INTENDED USE
This product is designed for heating and cooking foods in suitable pans or pots. Any other use may result
in damage to product or injuries.
The Imtron GmbH assumes no liability for damage to the product, for property damage or for personal
injury due to careless or improper usage of the product, or usage of product which does not meet the
manufacturer’s specified purpose.
IM_OBH26322V1_190604_V09_HR.indb 11
4/6/2019 15:22
