12
13
5 fill oil
note!
This procedure requires Öhlins Filling Machine. See separate manual for
Öhlins Filling Machine for proper use.
5.1
Use tool 01797-05 and tool 02810-01 to compress the Top out
spring with tool 01765-03. Keep the Top out spring compressed
during remaining steps of the filling procedure.
note!
Ensure that the Top out spring is fully compressed.
5.2
Turn the Shaft assembly to a horizontal position in the vice.
5.3
Use tool 01460-68 as a spacer in the cylinder tube to achieve
correct position for the Dividing piston. Use Adaptor without
O-ring as a stop by screwing it all the way into the Cylinder tube.
Handtighten only.
note!
O-ring shall not be installed on the Adaptor.
5.4
Remove the Fill screw. Check the O-ring. Replace if damaged.
5.5
Use tool 01820-24 together with the filling machine and mount it in
the filling hole in the Cylinder tube extension.
Fill the system (See
Öhlins Filling Machine Manual)
.
5.6
Disconnect filling machine and remove tool 01820-24.
5.7
Mount the Fill screw together with the O-ring. Tightening torque 3.5
Nm
5.8
Remove the Adaptor and tool 01460-68.
Warning!
It is important that you remove the Dividing piston positioning tool.
5 fill oil
5.1
5.2
5.3
5.4
5.5
5.8
approx 100 mm
approx
100 mm
