OHAUS SJX323, Instruction Manual

Page: 17 / 124

SCOUT
TM
SJX SERIES BALANCES EN-15
5. MAINTENANCE
5.1 Cleaning
WARNING:
Electric Shock Hazard. Disconnect the equipment from the power
supply before cleaning.
The housing may be cleaned with a cloth dampened with a mild detergent if necessary.
Attention:
Do not use solvents, chemicals, alcohol, ammonia or abrasives to
clean the housing or control panel.
5.2 Troubleshooting
The following table lists common problems and possible causes and remedies.
If the problem persists, contact OHAUS or your authorized dealer.
TABLE 5-1
Symptom Possible Cause
Cannot turn on No power to balance
Poor accuracy
Improper calibration
Unstable environment
Cannot calibrate Security switch in locked position
Err 8.1
Weight exceeds power on zero range.
Err 8.2
Weight below power on zero range.
Err 8.3
Over load (weight exceeds rated capacity)
Err 8.4
Under load (pan removed)
Err 8.5
Tare out of range
Err 8.6
Displayed value exceeds 999999 (possible in Totalization mode)
Err 8.7
Unknown internal weight position
ref.err
Parts counting or percentage error – sample weight <1d. Balance
shows error then exits parts counting or goes to [ Clr.APU ].
Lo.ref
Percent Reference weight or APW is too low for accurate results
CAL E
Fail to do calibration.
USB.Err
Cannot find menu or app file in U-disk.