Quick Start Guide
CS Series Scales
Ohaus Corporation www.ohaus.com
i
CS Series Scales
Quick Start Guide
PREPARATION FOR USE
Check Power
For AC power, be sure local line voltage
matches voltage printed on the scale’s power
adapter. If not, do not use AC power.
To use battery power, remove battery cover
and insert three LR6 (AA) batteries.
Remove Spacer, Install Pan
Remove the red transport spacer: slide it back
and off. Place the stainless steel pan (if
provided) on the weighing platform. (The scale
can be operated without the pan, if desired.)
Allow at least 30-60 seconds warm-up time,
for scale to stabilize before operation.
SELECTING THE LOCATION:
Place on a firm, steady surface with sufficient space.
Avoid excessive air current, vibrations, heat sources, or rapid temperature changes.
SAFETY PRECAUTIONS
For dependable operation of this product, observe the following precautions:
•
Verify that the input voltage printed on the power Adapter and the plug type
matches the local power supply (if using AC power).
•
Make sure that the power cord does not pose an obstacle or tripping hazard.
•
Disconnect the product from the power supply when cleaning.
•
Do not operate this product in hazardous or unstable environments.
•
Do not drop loads on the pan.
•
Use only approved accessories and peripherals, as available.
•
Operate the product only under ambient conditions specified in the Instruction
Manual.
•
Service should be performed by authorized personnel only.
Remove red
transport
Spacer
Stainless
steel pan
rests atop
weighing
platform.
