Courier 7000
EN-11
3. OPERATION
3.1 Turning On/Off the Scale
To turn on the scale, you can press the
On
button. The scale performs a display test, and momentarily displays
the software version, the GEO value and then enters the last active weighing mode.
NOTE
: If the hardware lock switch is enabled,
LFt ON
will also be displayed briefly.
To turn the scale off, you can long press the
Off
button until
OFF
is displayed.
3.2 Setting the Display to Zero
The value of the display can be set to zero under the following conditions:
1. Automatically at Power On (Initial zero).
2. Semi-automatically (Manually) by pressing the
ON/ZERO Off
button.
3. Semi-automatically by sending the
Zero
command (Z or alternate zero command).
If you want to set the value of the display by pressing the
ON/ZERO Off
button, please make sure that the
scale is stable.
3.3 Changing the Units of Measure
To change the weighing unit, you can long press the
Print Units
button until the wanted weighing unit appears
on the display.
3.4 Printing Data
Before you print out the displayed data with a printer or sending the data to a computer, please set the
communication parameters in the
Print Menu
(Refer to 4.7 Print Menu).
You can press the
PRINT Units
button for sending the displayed data to the communication port.
3.5 Application Modes
Activating / Deactivating the Application Mode
To activate or deactivate the application mode, you can do the steps that follow.
1. Long press the
Menu
button until
mM.E.N.U
appears on the display.
2. Release the
Menu
button, and
C.A.L
appears on the display.
3. Short press the
No
button several times until
mM.O.d.E
appears on the display.
4. Press the
Yes
button to enter the application mode.
5. Short press the
No
button several times until the wanted selection appears on the display.
6. Press the
Yes
button, and
ON
appears on the display. If you want to activate the application mode, short
press the
Yes
button. If you want to deactivate the application mode, short press the
No
button until
OFF
appears on the display, then short press
Yes
button.
3.5.1 Weighing
This mode is the default factory setting, and it is used to determine the weight of the loads in the selected unit
of measure.
Entering the Mode and Starting to Weigh
To enter the weighing mode, you can do the steps that follow:
1. Long press the button
Function Mode
until
wWEIGH
appears on the display.
2. Put the container on the scale. Once the value is stable, you can see “*” on the display.
3. Press the button
Tare
to
tare. If the scale performs well, you can see the value on the display is 0.
4. Put the load on the container and read the weight value of the load from the display. Once the value is
stable, you can see the “*” is on the display.
NOTE:
You can check the value of the tare weight by long pressing the
Tare
button.
The Weighing configurations are defined below (Defaults in Bold).
Item
Available Settings
Comments
Weighing (
wWeIGH
)
On
, off
To enable or disable Weighing
NOTE:
You cannot disable the Weighing mode if you are in the mode currently.
Summary of Contents for Courier 7000
Page 1: ...Courier 7000 Instruction Manual...
Page 2: ......
Page 4: ......
Page 61: ...Courier 7000 EN 57 11 5 Column Kit Installation 1 2 3 4 5 6...
