OHAUS Courier 7000, Instruction Manual

Page: 28 / 63

EN-24 Courier 7000
Stop bit
[
StOP
]
Set the number of stop bits.
1 bIt
= 1 stop bits
2
bIt
= 2 stop bits
Handshake
[ H.SHAKE
]
Set the flow control method. Hardware handshaking is only available for COM1 menu.
NONE
= no handshaking
ON-OFF
= XON/XOFF software handshaking
Alternate Print command
[
Alt.P
]
Set the alternate command character for Print.
Settings of A (a) to Z (z) are available. The default setting is P .
Alternate Tare command
[
Alt.t
]
Set the alternate command character for Tare.
Settings of A(a) to Z(z) are available. The default setting is T .
Alternate Zero command
[
Alt.z
]
Set the alternate command character for Zero.
Settings of A (a) to Z (z) are available. The default setting is Z .
NOTE
: Setting of
P
,
T
and
Z
are not available in more than one command options.
End
[ ENd ]
Advance to the next menu or return to the top of the current menu.
4.7 Print Menu
You can set the parameters with the Print menu. Default settings are in bold .
Menu Sub-Menu
Sub-Menu
(In segment)
Options
Options
(In segment)
Print
(
P.r.i.n.t )
Reset
reset
no
, yes
NO , yes
Assignment
ASSIGN
Demand , Auto On Stable,
Auto On Accept,
Interval(seconds), MT-
Continuous, OH-
Continuous, SICS, NCI,
8213, 3835, SCP01
DemMaN , ON.Stab ,
ON.ACep , INter ,
mMt.CON , OH.CON , SICS ,
NCI , 8213, 3835, SCP01
Stable Weight Only
[Demand]
Stable
Off , On (LFT Force On)
OFF , ON
Mode
[Auto On Stable]
mMODE
Load , Load and Zero
LOAD , LOAD;2r
Time
[Interval (seconds)]
tImME
1
~5000
/
Content
CONtNt
Result , Gross, Net, Tare,
Header, Footer, Mode,
Unit, Info
result , GrOSS , Net ,
tArE , HEAdEr FOOtEr ,
mMOdE , UNIt , INFO
Layout
LAYOUt
Format , Feed FOrmMt , FEEd
End
ENd
/
/
NOTE
: / indicates that it is not applicable in the table above.
Reset
[
reset
]
Reset the Print menu to factory defaults.
NO = do not reset
YES = reset