OHAUS AV114C, Service Manual

Page: 46 / 108

3-22
CHAPTER 3 REPAIR PROCEDURES
3.2.8 InCal Motor Removal/Replacement (Cont.)
InCal Motor Replacement (Cont.)
5. Install the InCal Motor to the InCal Mechanism, the motor shaft must be in the position as
shown in Figure 3-28. The InCal Motor shaft must be in the fully counter-clockwise position.
6. Secure the InCal Motor and InCal Motor Shield to the InCal Mechanism with the screws
previously removed.
7. Replace the MFR Load Cell, refer to paragraph 3.2.7.
3.2.9 InCal Mechanism Removal/Replacement
InCal Mechanism Removal
NOTE: Replacement InCal Mechanism's are supplied assembled with the InCal Motor installed.
1. See Figure 3-30 and remove the 3 screws as shown from the InCal Mechanism.
3-Mounting Screws
Figure 3-30. InCal Mechanism Mounting Screws.
Figure 3-31. Removing the InCal Mechanism.
2. See Figure 3-24 and slide the InCal Mechanism to the right to remove
3. See Figure 3-26. Rotate shaft until weight is lowered, then remove the weight.