Officezone RHIN-O-TUFF OD 3500, Instruction Book

Page: 6 / 29

2) Placing your machine in the proper location:
Place the machine on a hard level surface placing the foot pedal on the floor in
front of the machine. Set aside some room for the books that have to be punched
and also some room for the books that had already been punched.
3) Providing power to the machine:
Plug one end of the power cord into the back of the machine. The other end goes
into the wall outlet. Install the foot pedal plug into the receptacle, which is located
on the left side of the machine. The optional Versa switch can be plugged into
the same receptacle if this option is to be used.
4) Die installation: Diagram 1
Make sure the machine is turned off before installing die. Install the die (1) by
sliding it into the opening of the machine located on the left-hand side of the
machine, Make sure the punch pin retainer (2) slides into the slot of the pusher
bar. Using the two fluted knobs (3) provided with the machine, install each
handle into the hole located in the front of the die and turn them clockwise to
tighten. Make sure there is n o paper dust in the machine die slot before installing
the die.
Diagram 1
+ To remove a punch pin from the die:
Make sure the machine is turned
off
before removing the die. To remove a punch
pin from the die, remove both fluted knobs and slide the die to the left just