11
After Completion of Work
Switch off burner/thermostat switch (23) – pos. "0". Run machine in cold water
mode for a couple of minutes.
Close spray pistol.
The unit to be switched off by means of the ON/OFF switch (2) – pos. "0".
De-pressurise the spray pistol by shortly opening and closing.
Disconnect the unit from the water and power sources.
Reel off high pressure hose and thoroughly clean it. In case of damage
replace it for safety reasons.
Using other materials than original OERTZEN equipment (hand nut respec-
tively hose marked with “OERTZEN”) or using materials which have not
expressively been approved by OERTZEN in writing ceases warranty and
product liability.
Reel up high pressure hose properly, without loops.
Store equipment in a dry, frost-protected area.
In case of extended shut-down periods drain pump completely.
Particularly Note
In case of malfunctions switch off machine immediately, eliminate cause
according to chapter "Trouble Shooting", call qualified service.
During shut-down periods of more than 3 minutes switch off machine by
means of the ON/OFF switch (2) – pos. "0".
If frost is likely, frost protection of the machine is a must, as otherwise severe
damage could occur.
After work the spray pistol to be locked by means of the safety lever.
