OEM DRAUGHT CAP MOTORIZED 30, Instructions For Use And Warnings

Page: 49 / 66

CAPPA NEUTRA/MOTORIZZ. serie 30/35/40
CHAPTER 5 –
TRANSPORT AND INSTALLATION
Page 49
5.5 Connections
For the starting of the oven, the necessary connections to local networks must be ensured:
•
electrical connection (including grounding connection),
compliant with the rules in the country of installation.
It is the user's responsibility to ensure the required connection features.
ATTENTION!
The required connection must be made by qualified and authorised personnel.
5.5.1 Electrical connection
ATTENTION!
The electrical power cables are charged to the customer and must be sized according to the
maximum current absorbed.
Use a flexible cable under an oil-resistant sheath that should not be lighter than polychromelene or
synthetic elastomer cables under equivalent sheath (designation 60245 IEC 57).
ATTENTION!
Before performing any electrical connection operation, it is important to check that the machine is
turned off. Then place the general switch on "0" - "OFF".
ATTENTION!
Ensure that the customer power line has been pre-dissected.
The connection between the oven and the grounding system is up to the buyer.
ATTENTION!
The operation must be performed exclusively by specialized and authorized personnel (electric
maintainer).
Before proceeding with the electrical connection, make sure that:
•
the maintainer is aware of the regulations in the country of installation;
•
the frequency and power voltage values of the machine match the values of the power supply;
•
the section of the used electrical cables is adequate for absorption;
•
the power line is adequate to withstand the maximum absorptions of the oven;
•
the grounding of the circuit complies with EN 60204-1 standards;
•
materials used in the grounding system have adequate solidity or adequate mechanical protection.
ATTENTION!
Do not operate with hands and damp objects.
In the event of a fire, do not use water on electrical components.
IMPORTANT!
The electrical connection is provided with a cable, which must be connected to the power grid by
specialized personnel (electrician).
IMPORTANT!
The cap must be connected to a general omnipolar switch that interrupts all contacts including
neutral, with distance between open contacts of at least 3mm, with megnetothermic safety fuses or
with protective fuses. In addition, the general switch must be located in the vicinity of the device and
easily accessible.