INTRODUCTION // READ THIS FIRST!
BEFORE YOU BEGIN USING THE ODYSSEY7, WE STRONGLY SUGGEST
YOU REVIEW THE INCLUDED QUICK START GUIDE. WE ALSO
STRONGLY RECOMMEND THE FOLLOWING:
1. Always record to the INTERNAL MEDIA OF THE CAMERA; this is critical for proper
timecode and ideal for dual media / backup.
2. DO NOT REMOVE THE FOUR SCREWS FROM REAR OF CASE. This may result in
damage to the OLED panel. Such damage is not covered by warranty.
3. Power and Cabling: Make sure you have PROPER POWER (6.5-34VDC), plugged in to
the proper power port (left side of recorder), and that 3G-rated SDI cables are used.
4. Power source must be able to provide up to 24 watts at all times to the Odyssey7.
5. When powering the Odyssey7 from an ARRI ALEXA camera, we recommend using the
24V R/S Fischer-3 output from the ALEXA using the optional Convergent Design cable.
6. Familiarize yourself with the equipment and test prior to shooting.
7. Before using the SSDs it is IMPERATIVE TO FORMAT them in the Odyssey7.
Formatting SSD media is a DESTRUCTIVE PROCESS; any existing data will be lost
during format.
8.
Ensure that the camera’s viewfinder data is not being recorded; IF YOU SEE
VIEWFINDER DATA ON THE ODYSSEY7 monitor, then it will be recorded! In a future
update, if your camera can provide both clean and data-overlayed video feeds, it will be
possible to monitor one while recording the other.
9. NEVER DELETE ANY FILES OFF AN SSD FROM A COMPUTER, except when going
through a firmware update procedure.
10.
While we recommend that you always maintain the latest firmware on your Odyssey7,
WE DO NOT RECOMMEND UPDATING FIRMWARE IF YOU ARE IN THE MIDDLE OF
A SHOOT (unless specifically instructed to do so by our Technical Support staff).
11.
When offloading media, ALWAYS MAKE A BACKUP COPY, ideally to a RAID1 drive.
12.
Be sure to allow the Odyssey7 to finish closing a Record file before taking any further
action.
13. Always safely eject SSD Media by pressing the
button before removing SSD media
from the Odyssey7.
2
