Odom ECHOSCAN, Manual

Page: 30 / 44

04/26/02 30
Revision 1.11
Switch number 6 sets the SPU to “flash” mode. This should only used when
upgrading the ECHOSCAN embedded software. If not used property, all
software could be erased rendering the unit inoperable.
Flash Mode 6=OFF
Normal Mode 6=ON
Switch number 7 identifies the unit as part of a dual head system.
Dual ECHOSCAN 7=OFF
Single ECHOSCAN 7=ON
Switch number 8 is activated (OFF position) when the ECHOSCAN is triggered
externally as in the case when an ECHOTRAC single beam is used as the
system controller.
External Trigger 8=OFF
Internal Trigger (Normal) 8=ON