6
1. Attach pedal lever
a. Remove bolt from 3-pivot link.
b. Place right pedal lever (E) through leg slot in rear shroud and
attach it to the 3-pivot link.
Check to see that the rollers are
seated and properly aligned on the rails before securing
the pedal lever.
c. Tighten the bolt and nut securely using 17mm socket and
wrench.
2. install console mast
a. Assemble the console and mast (B) by placing the keyhole slots
in the mast plate over the bolts and sliding it forward and down
(away from the pedals).
b. Tighten the four 6mm hex key bolts attaching console mast to
frame.
c. Connect the main cable connector and the mast connector.
Listen
for a click to make sure it is a positive connection.
d.
Insert the supplied cable tie (M) through the small hole
to secure the cable to the frame. Push the excess cable
into the console upright tube.
3. Attach arms
—
Arms are labeled left and right, be sure to
install accordingly.
a. Install moving handlebar (F or G) with four 6mm hex key bolts
(K) on each side—
make sure these bolts are very tight.
b. Position the handlebar cover (H) over the handlebar pivot point
and press firmly to attach.
c. Repeat for the other side.
