Octagon SF 1008 HD, User Manual

Page: 79 / 88

39
3. Installation
3.1 Dish Setting
Select the satellite/antenna and LNB settings for service search.
The values that are set in this menu will be available for selection
in other service searching menus.
 Satellite : Select the satellite which you want to do a search
for.
-
Press the LEFT/RIGHT ARROW button to select the satellite.
- If you press the OK button, the entire satellite list will be
displayed.
- Select the desired satellite name to search.
- If the desired satellite name is not listed then select User
Defined.
 Frequency : Select the satellite frequency which you want to use for checking the signal.
 LNB Power : Select the LNB power on or off.
 LNB Type : Select the LNB type.
 LNB Frequency : Select the local oscillator (L.O.). frequency that is specified for the LNB used..
-
Use the LEFT/RIGHT ARROW buttons to select the LNB frequency.
- If the required LNB frequency is not listed, then enter the frequency manually using the NUMERIC
buttons.
- When you select Universal LNB type, both 9750 and 10600 are supported at the same time. And
then the LNB 22KHz setting is disabled.
 LNB 22KHz : When you use a separate coax 22 KHz tone switch box, make the 22 KHz tone switch
enabled or disabled to select the input you desire of the tone switch.
 DiSEqC Switch : If you use DiSEqC 1.0 or DiSEqC 1.1 switch, select one of the DiSEqC inputs.
 Service Search : Press the OK button to move to the Search Menu
3.2 Positioner Setting
 Satellite : Select the satellite which you want to search for the
Service.
-
Press the LEFT/RIGHT ARROW button to select the satellite.
- If you press the OK button, a complete satellite list will be
displayed.
- Select the wanted satellite name.
- If the desired satellite name is not listed then select User
Defined.
 Frequency : Select the satellite frequency you want to use to
check for a signal.
 Positioner : Select the positioner.
-
None : (No Positioner)
-
Using DiSEqC 1.2 :
Move :
To move the dish, press LEFT/RIGHT button.
Fine Move :
To move the dish in smaller steps, press the
LEFT/RIGHT ARROW button.
Step :
Set to positioner moving steps as 1, 2, 3, 4
Positioner Command :
To use various positioner commands,
press the OK button. Then, available positioner commands
will appear.