www.octagonsystems.com
Page 17 of 22
Table 6 - Multi I/O Pin-Out
Signal Name
Pin #
Pin #
Signal Name
PT02E1210S
(rear view)
F
A
B
C
D
H
G
J
K
E
CAN H
A
F
Digital IN 0
CAN L
B
G
Digital IN 1
CAN GND
C
H
D I/O GND
Reserved
D
J
Digital in 2
Digital Out 0
E
K
Digital in 3
Mating Connector PT06E12-10PSR
Software and Hardware Development
Although Octagon Systems will build complete ready-to-install units, users will often need to
first test different configurations and expansion modules. This chapter covers internal
connectors and functions.
Opening and closing the MOBL-D2 box
The back endplate of the MOBL-D2 can be removed for access to the compact flash. The bolts
require a 4 mm hex wrench.
Access to the SIM card socket (used with some cellular / wireless WAN options), and/or
access to the expansion connectors requires removal of the front plate & CPU board as an
assembly. Contact Octagon Systems Technical Support for complete instructions prior to
disassembling the unit.
CAUTION! Octagon Disassembly Instructions Must Be Followed!
When replacing the front and back faceplates ensure the threads
on the bolts are properly aligned before tightening. Do not over
tighten. Torque to 1.1 N-M (10 in-lbs.) Failure to follow these
precautions could strip the internal threads.
