46
Cleaning the TV
IMPORTANT
The power cable has to be removed from the socket before cleaning
the TV.
Do not use volatile solvent (alcohol, rosin, and toluene) to clean the
TV. These types of chemicals might damage the housing and the
LCD glass.
Cleaning the bezel and remote control
Use a 100% cotton cloth or micro-fiber cloth for cleaning.
If the remote control or bezel is dirty to the point where you cannot
simply dry wipe it, please lightly dampen the cloth (the cloth cannot
be dripping wet, because if water drips into the panel it will cause
malfunction and possible permanent damage to the panel which will
not be covered under the warranty) with clean water and wipe again.
Wipe the display with a dry micro-fiber cloth or 100% cotton cloth
afterwards.
Please Note :
Make sure you wring the water out of the cloth before cleaning the
bezel or remote in order to prevent water from penetrating into the
electronics.
Cleaning the Screen
Use a 100% cotton cloth or micro-fiber cloth for cleaning.
The LCD screen glass is extremely fragile. Do not scrape it with any
material. Do not press or tap the screen to avoid cracking. When
the screen is dirty to the point where you cannot simply dry wipe it,
please lightly dampen the wiping material with clean water and wipe
again. Wipe the display with a dry micro-fiber cloth or 100% cotton
cloth afterwards.
1.
2.
1.
2.
r
1.
2.
Frequently Asked Q&As
Q: How do I program my cable or satellite remote to control
my TV?
A: Call up your cable or satellite TV company and ask for
SONY®TV’s universal remote code.
Q: Does this TV support digital cable without a box?
A: No, this TV does not have a QAM tuner built in.
Q: Why is there no video after I connected my cable / satellite
box to the TV with yellow, red, and white plugs but TV shows
no video.
A: Press the SOURCE button on the remote, make sure you
are on the source called AV. Please also reference page 27
under setup to confirm you did connect the cables in the cor-
rect place.
Q: Why is there no video after I connected my antenna?
A: You need to use the TV menu to scan for channels.
Q: Why is there no video after I connected my cable / satel-
lite box with coax cable (the old style cable with needle in the
middle and a ring to tighten the connection)?
A: Did you make sure to switch the signal type to cable and
change your TV channel to the correct one? Check page 2
for more instructions.
Maintenance