03.
Fix the sides of the seat base box (A) to the Den shell using 6x M6 x 45mm machine
screws (Q) and 6x 30mm washers (R) in the holes marked above. Passing the bolts
(Q) through the washers (R) and holes in the side of the base box (A) into the inserts in
the Den panels.
04.
Then fix the back of the seat base box (A) to the Den shell, using 8x M6 x 45mm
machine screws (Q) and 8x 30mm washers (R) in the holes marked above. Passing
the bolts (Q) through the washers (R) and holes in the back of the base box (A) into
the inserts in the Den panels.
Q - M6 x 45mm machine screws &
R - 30mm washers
DEN Seat Assembly Instructions
A
A
Q - M6 x 45mm machine screws & R - 30mm washers
DWG No: SASS-0100
Revision: -
Drawn by: CE
Drawn date: 01/12/15
Q
R
Q
R
02.
Before assembling, make sure that all the levellers are set so that the bottom of the
base box (A) is flush with the bottom of the Den panels (nominally 20mm from the
ground).
01.
All inserts are indicated by the circular white stickers, as shown above. Locate the
inserts through the fabric in the holes indicated above and pierce using a sharp pointed
tool such as a bradawl or the end of a screwdriver, in preparation for passing bolts into
inserts.
Alternatively, carefully make a small cross cut (approx 10mm across) using a sharpe knife
over each of the indicated holes.
14x Insert Indicator Stickers
20mm
A - Seat | Base Box
Panel
Levellers
A
A
