X-SERIES
X4 / X8 / X16
.
INSTALL & OPERATION MANUAL
5
3
Preparing the Hull
OceanLED recommends using a qualified installer / technician when making modifications to your vessel.
Please also consult the manufacturer for more detail on modifications and installation.
OceanLED recommends use of provided screws: No.6 (3.5mm) x 1 inch (25mm) Pozi Self Tapping Pan Head
Screws - Stainless Steel. If alternative screws are used, do not use counter sunk or non-flat shoulder screws
to secure your lights to the hull (failure to do so will invalidate your warranty).
OceanLED does not recommend using the stainless steel bezel on conductive hulls (e.g., carbon fibre,
aluminium/steel).
If the lights (with plastic bezel) are to be fitted to a conductive hull or any other metal surface/ outboard jet
bracket, Isolating Mounting Kit must be used. Please contact OceanLED for additional details.
Isolating Mounting Kit
4x M3.5 x 35mm Nylon Bolt
4x Nylon Washer
4x M3.5 Nylon Nut
(1x spare of each component)
Part Number:
019913 - D3 and X-Series Isolating Mounting Kit
Depth/Spacing
Ideally mount your lights at similar depth levels to ensure matching colour consistency through the water. Deeper lights
will look duller and possibly differ in colour compared to shallower mounted units.
Spacing / Install Depth
X4 / X8 / X16
Recommended Spacing
0.5-1m (2-3
’)
Recommended Installation depth (From the light waterline)
100-200mm (4-8
”)
Hole Cut Out
Hole Cut out size: 12.5mm (
1/2”)
Overall Dimensions
See overall dimension schematic
– See Appendix (Section 7.1)
