CONTROLLER
KITs
.
2021 INSTALL & OPERATION MANUAL
6
2.4 FINALISE YOUR INSTALLATION (EXPLORE E6 & E7)
Always test the system BEFORE the boat goes back into the water. Typical OceanLED light installs require
the boat to be hauled out of the water to replace light units.
The DMX standard recommends a maximum of 32 devices to be connected in one chain. If installation
requires more lights than this, please contact OceanLED for advice.
1. If Wi-Fi is required connect Ethernet cable from back of controller panel into a suitable Wi-Fi router or Wi-Fi
enabled network. (The controller is DHCP enabled as standard so should be detected by the network once
powered).
2. Connect the control cable to the control input of the first Explore E6 light. Then connect a control link cable to
the next, and so on up to the last light in the chain.
3. Fit the supplied terminator to the output of the last E6 light. See the following example of the connections:
