SPORTS SERIES
DOCKLIGHT
.
INSTALL & OPERATION MANUAL
14
POWER CABLE REQUIREMENTS
It is important to select the correct size cable for the supply to the dock lights. The required cable gauge depends on
the current draw and the length of the cable run from the power source to the light(s). Note that where the power source
is remote from the power junction box connected to each light, this cable will carry the total current for all the connected
lights, and should be sized correctly to prevent excessive voltage drop and power loss.
The cables from the power junction box to the lights themselves can be a smaller gauge, but again should be correctly
selected depending on their length to prevent excessive voltage drop. Please refer to the cable gauge diagram in the
Appendix.
THE SUPPLY CABLE MUST BE PROTECTED BY A SUITABLE FUSE OR BREAKER.
3.3 FINALIZE YOUR OCEANLED INSTALLATION
Test your lights
At this final stage make sure all of the system is operational. See Chapter 3 Operation. If you have any issues, please
contact your local OceanLED representative.
