Preface
READ AND FOLLOW ALL INSTRUCTIONS IN THIS MANUAL
WARNINGS
Before installing your OceanLED Eyes Camera, please read and follow all warning notices and instructions
which are included. Failure to follow safety warnings and instructions can result in property damage, severe
injury or even death.
Ensure the bonding point of the camera is fitted to the cathodic protection system on the vessel. Check
conductivity between earth bonding point and aluminium bronze / stainless front bezel. If mounting the
camera to metal, carbon fibre or wooden hull, ensure that suitable measures have been put in place to
account for the effects of galvanic corrosion i.e. use of Delrin sleeve components (Isolation Kit).
Salt is an inherently corrosive material. Metal parts and certain natural and man-made surfaces are
particularly susceptible to corrosion and deterioration when used in and around saltwater. Some OceanLED
products contain combinations of plastic and polymers which are impervious to salt water corrosion,
however, screws and fasteners used for the installation must be of a marine grade type stainless steel or
equivalent and monitored annually to ensure the camera remains in service for years to come.
All electrical connections should be fully waterproofed. Problems caused by water ingress into connections
will invalidate warranty. Also ensure the rear of the camera is in a dry area and not subject to a wet
environment. Failure to do this may invalidate warranty.
Never Use Solvents! Cleaners, fuel, and other products that may contain strong solvents, such as acetone,
that attack many plastics greatly reducing their strength and irreversibly damaging the special lens coatings
and cable sheathings.
DANGER
RISK OF ELECTRIC SHOCK OR ELECTROCUTION
This camera must be installed by a licensed or certified electrician in accordance with all applicable local
codes and ordinances. Improper installation will create an electrical hazard which could result in death or
serious injury to swimmers, installers, or others due to electrical shock, and may also cause damage to
property. Always disconnect the power to the camera at the circuit breaker before servicing the camera.
