EXPLORE
E7
2020 INSTALL & OPERATION MANUAL
7
Installation (Once hull preparation is complete)
1. Test light(s) before fitting.
2. If using a Delrin Isolation Kit, insert the Isolation Kit front washer into the drilled hole and apply marine sealant to
seal between the Front Washer and the hull.
3. Apply sealant to the rear of the mounting tube
assembly’s bezel to ensure a complete unbroken seal around
the light.
Make sure sealant fills in the recess groove on the reverse of the light bezel:
4. Ensure the light angle is correct for the location before fitting the light. If available, follow the OceanLED Light
Placement Chart (LPC) where the required angle for each light position around the hull will be detailed. The
LED Indicator is used as a reference point for beam direction. For example, if viewed from the rear with the
LED Indicator at the top, the beam will be pointing upwards. The OceanLED logo on the reflector also indicates
the direction of the beam
– see below. For further details, see the diagram in the Appendix (Section 7)
5. Insert the complete light unit (mounting tube as light cartridge) into the hull, pressing the light hard into
the hull and twist slightly to spread the sealant behind the light to ensure good adhesion.
This process is made much easier if a second person is inside the hull to receive the light and install the
locking equipment whilst supporting the light from the outside. Breakages due to lights falling out of the hull
are NOT covered under warranty and can cause serious bodily injury as can any falling object.
Beam
Direction
