EXPLORE
E7
2020 INSTALL & OPERATION MANUAL
18
5
Operation / Maintenance
5.1 OPERATION
Never connect / disconnect lights with power applied as irreversible damage may occur.
Switch Control
The Switch Control mode allows the user to switch between colours and strobe modes using a push switch.
The sequence for the Explore E7 Dual White/Blue is a closed loop as follows:
1. Solid White
2. Solid Blue
3. Fade White / Blue
4. Strobe Blue
5. Strobe White
6. Strobe White / Blue
7. 50% White and 50% Blue
After step 7 the next button press will reset the sequence back to step 1.
The sequence for the Explore E7 Colours DMX is a closed loop as follows:
1. Solid Chosen Colour
2. Strobe Chosen Colour
3. Colour Cycle
If during the colour cycle (step 3), the switch is pressed again, the cycle will stop and the current colour will be stored
and remain static (i.e. go back to step 1 in the sequence, with a new stored chosen colour).
DMX Control
Please refer to the purchased DMX Controller for details about how to use it. For 3
rd
party DMX control see section
4.5.
5.2 LIGHT CARTRIDGE REMOVAL
– SINGLE MOUNTING TUBE
Before proceeding with this operation, you MUST seek permission from either the manufacturer or your
OceanLED representative.
DO NOT remove the light cartridge from the mounting tube during installation. The light cartridge MUST stay
fitted inside the mounting tube throughout the installation process to avoid the introduction of potential
contaminants that may damage the product.
Additional Tools required not supplied by OceanLED
•
Allen key (2mm).
1. Turn power off and unplug all the connectors on the back of light.
2. Remove the locking ring from the mounting tube.
3. Undo one of the six screws from the back of the light cartridge to allow the Explore Removal Tool to be placed
(see image below).