EXPLORE
E7
2020 INSTALL & OPERATION MANUAL
23
EXPLORE SERIES
PROBLEM
CHECK
CAUSE
FIX
Light does not
look bright
Check that there is no marine growth
on the lens
Marine growth
Clean the lens as per maintenance
advice
Check voltage supply to the light is
between 11V and 32V DC (The light
will still work between 10 and 11 volts
however at reduced brightness)
Voltage is either too
high or too low
Investigate reason for high or low
voltage and fix
Check voltage supply is stable and
does not fluctuate
Voltage is fluctuating
Investigate reason for voltage
fluctuation and fix
Check that the electrical connections
between the light and the supply
cable have been made correctly and
recommended cable gauge has been
used
Poor electrical
connection
Remake connection and seal joint
correctly
Confirm all LEDs are illuminated
1 or more LEDs are
not working
Contact your dealer.
Check lights to see if water is present
inside the light
Water present
Contact your dealer.
Check cable connections for
corrosion
If corrosion is present
It is not advised to reuse the cable if
water is present inside. Contact your
dealer for a replacement. This is
NOT covered by the warranty
Light has water
inside
Check integrity of lens
Light will require
replacing
This is not covered by the warranty -
Contact your dealer for a
replacement light. Only use genuine
OceanLED parts
Check connections to make sure
they are not submerged in water
Light will require
replacing
This is not covered by the warranty
Check cable to make sure there is no
damage to the cable
Cable will require
replacing
This is not covered by the warranty.
Only use genuine OceanLED parts
Checked all factors that are above,
and the light still does not work
Light faulty
Contact your dealer for a
replacement light
