67
Battery Installation
Slide a new 3 volt type CR2450 Lithium Battery, negative
(-) side down into the Battery Cavity. Slide it in from the
right side and ensure that it slides under the contact clip
on the left rim of the cavity (Fig. 73).
Orient the Retaining Bar across the lower portion of the
Battery and carefully push it down into position (Fig. 74).
Battery Hatch and Hatch Retaining Ring Installation
Replace the Hatch O-ring with a new one which must be a
genuine Oceanic part that can be purchased from an
Authorized Oceanic Dealer. Use of any other O-ring will
void the warranty.
Lightly lubricate the new Hatch O-ring with silicone grease
and place it on the inner rim of the Battery Hatch (Fig.
75). Ensure that it is evenly seated.
Slide the Hatch Retaining Ring, top portion first (small
opening), onto your thumb.
Carefully place the Battery Hatch (with O-ring) into posi-
tion on the rim of the Battery Compartment, then press it
evenly and completely down into place with your same
thumb.
Maintain the Battery Hatch securely in place and, using
your other hand, slide the Retaining Ring down off your
thumb and into position around the Battery Compartment.
Fig. 73 -Inserting Battery
Fig. 74 - Inserting Retaining
Bar
Fig. 75 - O-ring Orientation
Summary of Contents for Veo 180Nx
Page 1: ...Veo 180Nx Personal Dive Computer Operating Manual...
Page 76: ...76 NOTES...
Page 77: ...77 NOTES...
