SafeSea V100 User Manual
9
Version 0A.00 21/07/2011
To monitor a channel without adjusting squelch settings, press and hold
the
SQ
key until a double beep is heard.
Note: The squelch will remain open while the key remains pressed or will stay in this
mode until the key is pressed again for a double beep, depending on the mode selected
in the menu
Lights Adjustment
To turn the lights on or off and adjust the level, press the key. The
▲
or
▼
keys may now be used to adjust the backlighting level from off
through five levels to maximum. After two seconds of inactivity the
operation of the selection keys will revert to channel change.
Dual Watch
Press the
D/W
key to initiate the Dual Watch mode. The radio will now
start sampling the selected working channel selected and channel 16 for
signals.
Pressing the
D/W
or
▼
key will terminate Dual Watch.
Note: There will be no action if the radio is on channel 16 when the
D/W
key is pressed.
Tri-Watch
Pressing and holding the
D/W
key for 1 second will initiate a triple
channel watch between the selected working channel, the user
programmed Call channel and channel 16.
Pressing the
D/W
or
▼
key will terminate Tri-Watch.
Note: a working channel and call channel must have been entered before this key press
will have any action.
Scan
Press and hold the
SCAN
key until a double beep is heard. The radio will
now start scanning all the channels in the radio for a signal.
To exit the scan mode, press the
SCAN
or
▼
key.
Often a channel will appear to exhibit a permanent signal or is frequently
used for traffic that is of no interest. In this case when the scan has
stopped on the channel, pressing and holding the
SCAN
key until the
double beep is heard will inhibit the channel from being scanned.
Memory Scan
To enter the Memory Scan mode, press the
SCAN
key. The radio will now
start scanning only those channels that are entered into the scan memory
for a signal.
