Ocean Matrix OMX-SW5x5, Instruction Manual

Page: 10 / 30

Connecting the OMX-SW5x5
7
6 Connecting the OMX-SW5x5
This section describes how to connect the OMX-SW5x5 . In particular, how
to:
Connect the
OMX-SW5x5
rear panel (see section 6.1)
Control via RS-232, for example, using a PC (see section 6.2)
Control via RS-485 (see section 6.3)
Connect the audio inputs/outputs (see section 6.4)
Set the dipswitches (see section 6.5)
6.1 Connecting the OMX-SW5x5 Rear Panel
To connect the
OMX-SW5x5
, do the following
1
:
1. Connect up to 5 composite video sources
2
to the 5 BNC input connectors, and
connect
3
up to 5 balanced stereo audio sources
4
to the “AUDIO INPUTS”
terminal block connectors.
2. Connect
5
the 5 composite video output connectors to up to 5 composite video
acceptors
2
and connect the corresponding “AUDIO OUTPUTS” terminal
block connectors to the balanced stereo audio acceptors
4
.
3. Set the dipswitches (see section 6.5).
4. Connect a PC and/or controller (if required) to the RS-232 port (see section
6.2) and/or RS-485 port (see section 6.3).
5. Connect
4
the power cord
6
.
1 Switch OFF the power on each device before connecting it to your OMX-SW5x5. After connecting your OMX-SW5x5,
switch on its power and then switch on the power on each device.
2 For example, VCR machines
3 See section 6.4 for a description of how to connect a balanced/unbalanced stereo audio input/output
4 Not illustrated in Figure 3
5 When less than five outputs are required, connect only those outputs of the OMX-SW5x5 that are required, and leave the
other outputs unconnected
6 We recommend that you use only the power cord that is supplied with this machine