5
PREPARING THE SWITCH—Refer to instructions on the included CD
1. A switch is required when connecting point-to-many, many-to-point, or many-to-many.
2. If the switch supports IGMP to manage Group ID and DHCP to assign IP addresses to TX and RX automatically
then enable the DHCP switch —see SETTING THE IP ADDRESS on page 3).
3. If the switch does not support DHCP, include a DHCP device such as a router to the network/ethernet setup.
POINT-TO-POINT CONNECTION—Refer to instructions on the included CD
1. Connect cable ONLY when power is OFF.
2. Connect the source and the TX using HDMI cable.
3. Connect the HDMI looping output of the TX to the local HDMI display.
4. Connect another HDMI display to the HDMI RX using HDMI cable.
5. Connect the TX and the RX with Cat5e/6 cable.
6. Connect the IR TX cable to the IR TX port on the transmitter.
7. Connect the IR RX cable to the IR RX port on the receiver to control the source at the RX end.
8. Connect one RS232 cable from the PC or system to the RS232 port on the TX.
9. Connect one RS232 cable from the RX to the RS232 device to be controlled.
10. Plug in the included power supplies to turn on the TX and RX.
Ocean Matrix OMX-10HMIP0002 & OMX-11IPHM0002
Installation
Point to Point Configuration Examples
Ocean Matrix
www.oceanmatrix.com
