Luvalee Operations Manual
May 1, 2003
19
D. Bar B Q Grill
Assemble the grill and make sure the safety cable for the top is attached. Inserting the
base fitting in the center hole on the transom works best for access. To boil crabs, remove
the grating and place the pot directly on the lower heat deflectors. Placing the grill cover
on top of the pot will help speed up boiling.
DO NOT ATTEMPT TO BOIL CRABS IF
BOAT IS ROCKING. SEVERE BURNS FROM BOILING WATER MAY OCCUR.
6.
HEATING AND AIR CONDITIONING
A. CRUISAIRE HEAT/AC
The heating and air conditioning system uses considerable 110v AC current even though
it is an efficient heat pump. You will need to use the generator or shore power when
using this system.
Only 1 zone can be run when plugged into 30 amp shore power
.
To run two or three zones requires running the generator. Make sure you give the
generator at least 5 minutes to warm up before using it for this heavy electrical load.
When running, the heat pump will intake water and exhaust it at the port stern.
The breakers for the heating and air conditioning are in the forward (right hand) row of
the 110v panel. Each zone has its own set of controls to set temperature and control fan
speed. Operation requires the compressor and zone breakers to be set on.
MAKE SURE AIR CONDITIONING THROUGH HULL VALVES ARE OPEN
BEFORE OPERATING! Check to make sure water is coming out of the port side
transom. If not, the intake strainers may be plugged.
NOTE: Webasto and Cruisaire systems are independent of each other.
B.
Webasto Furnace – Primary heating system
The Webasto furnace is a diesel fired hot water heat system that runs off the 12 volt
system. The generator is not needed when running this furnace and it can be left on
Webasto Controls
Cruisaire Controls