STANDARD FEATURES
CABINET
The PAC series cabinet is constructed of 18 gauge steel with a gray polyester powder
coated finish that will compliment any decor. The entire cabinet is insulated with
sound- absorbing insulation for cool, quiet comfort. All units come equipped with handles
and swivel casters for portability and convenient set-up.
ELECTRONIC THERMOSTAT
All PAC units are equipped with a non-programmable electronic thermostat. When power is
connected to the unit, the thermostat will control the unit to cool a space to the desired
temperature. The thermostat is also capable of controlling the fan to operate automatically
when needed, or continuously. To protect the compressor from short-cycling, there is a
built-in time delay.
FAN SPEED CONTROL
A two position rocker switch, located next to the thermostat, provides the user with the option
of running the evaporator fan at high-speed or low-speed.
CONDENSATE TANK/PUMP
PAC series units come equipped with a means for handling the condensate generated
during the cooling process. All units,
except the PAC60 models
, come equipped with a
condensate tank. The tank can be easily removed from the unit and emptied as needed.
The PAC60 models come equipped with an Automatic Condensate Pump that removes the
condensate. The pump comes with a 20 foot long vinyl hose that allows for the removal of
the condensate water to a drain. The automatic pump is capable of a 20ft vertical lift, to
handle various installation requirements.
CONDENSATE ALARM LIGHT
On the front of all PAC models, there is a Condensate Alarm Light (RED) located near the
thermostat. For models other than PAC60, the light indicates that the condensate tank is
full, and needs to be emptied. PAC60 units, the light indicates a condensate pump
over-flow condition where the pump is either disabled or restricted, and cannot remove the
condensate water, and must be serviced.
FILTERS
All PAC series units are equipped with washable filters at the air intakes. Electrostatic mesh
air filter located behind the evaporator return air grille serves to filter the air before it is
cooled. A 1/2” aluminum mesh filter serves to protect the condenser coil from dust build-up.
Both filters can be easily removed and cleaned.
HIGH PRESSURE SAFETY SWITCH
Located on the back of the PAC unit is a manual re-set high pressure switch, used for the
protection of the compressor. If the condensing pressure exceeds the limit setting, the switch
will cycle the compressor off, while the evaporator fan remains running. The compressor
can be re-started, once the condensing pressure has equalized, by depressing the
“RESET”
button.
POWER CORDS
All PAC units come standard with a power cord for a convenient connection. All models,
except for the 3-phase units and 5-ton units, are equipped with a LCDI for added safety
features.
3
Summary of Contents for AIR BOSS PAC12
