Oce DFS10, Operator'S Manual

Page: 27 / 90

Making the books 21
Book-making overview
Below is an overview of the steps involved in the basic book-making process. The remainder
of this chapter contains detailed instructions for each of the steps.
1. Determining the correct spine width.
Before beginning the binding process, you should determine the thickness of the copy set
and the correct spine width of cover to use. Failure to do so will cause unnecessary delays
and inconvenience to you.
2. Selecting the cover supply.
Once you have determined the correct spine width, you must select the cover supply. If
you are in the on-line mode, you must use the Cover Trays as the cover source. If you are
in off-line mode, you either can use the Cover Trays or add the covers manually.
3. Loading the cassettes into the Cover Trays.
This step is applicable only if you have selected one or both Cover Trays as the cover
source. When a selected Cover Tray is empty, or contains the incorrect covers, you must
load the correct cassettes into the Cover Tray.
4. Producing the books.
The procedures for producing books vary depending on which of the following methods
of operation you are using:
• Automatic operation (on-line mode)
When you use this method, the host copier feeds the copy sets to the DFS10.The
DFS10 inserts the covers for the copy sets from the selected Cover Tray(s).
• Manual operation (off-line mode) with the Cover Tray. When you use this method,
you must insert the copy sets without covers into the DFS10. The DFS10 inserts the
covers for the copy sets from the selected Cover Tray(s).
• Manual operation (off-line mode) without the Cover trays.
When you use this method, you must disable the Cover Trays and insert the copy sets
with covers into the DFS10.