Occhio Sento, Mounting Instructions

Page: 32 / 48

30
Fitting/replacing the Sento inserts
Press out the release pin as far as it will
go.
If a combination of two glass inserts is
used, the satinised glass is fitted on the
inside.
Insert the soft-edge glass so that the sa-
tinised surface is on the inside. A further
glass insert (filter/lens) is always fitted on
the smooth side of the soft-edge glass.
Insert the edge of the glass insert into
the two springs and press against the
springs.
Holding it in this position, clip the edge
of the glass insert into the notch on the
release pin.
For assembling the Sento spot, see p. 32.
Caution:
Switch off the lamp before replacing
the reflector head and allow it to cool
down for one hour.
$
If necessary, remove the reflector head
from the socket holder (see p. 36).