VAN1LED INSTALLATION INSTRUCTIONS
Thank you for buying RAB lighting fixtures. Our goal is to design the best quality products to get the job done right. We’d like to hear your comments.
Call the Marketing Department at 888-RAB-1000 or email: [email protected]
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE
.
Fixtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding is required
for safety. Vandalproof fixtures are for indoor or outdoor use and should not be used in areas with limited ventilation or high
ambient temperatures. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A
PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
WARNING: Make certain power is OFF before installing or maintaining fixture.
CAUTION: For proper weatherproof function all gaskets must be seated properly and all screws inserted and tightened
firmly. Apply weatherproof silicone sealant around the edge of the Back Box, Lens and/or Junction Box. This is especially
important with an uneven surface. Silicone all plugs and unused conduit entries.
LOCATION
COVERED CEILING MOUNT ONLY
SUITABLE FOR WET LOCATIONS
CEILING MOUNTING
1.
Loosen
Tamperproof Screws
to remove
Refractor
from
Mounting Plate
.
2.
Attach
Universal Mounting Bar
to
Junction Box
with
bar screws (provided).
3.
Feed
Supply Wires
through
Mounting Plate Gasket
.
4.
Use “S” shaped
EZ Hang Hook
to hold
Mounting Plate
near
Junction Box
during wiring. Make appropriate
wiring connections.
5.
Attach ground wire(s) to
Green Ground Screw
(already
in place on
Universal Mounting Bar)
.
6.
Remove
EZ Hang Hook
and discard.
7.
Align
Mounting Plate
with
Mounting Plate Gasket.
Secure Mounting Plate to
Junction Box
by tightening
O-Ring and 1/4-20 Bolt
into center hole in
Mounting
Plate
.
8.
Secure
Refractor
back onto
Mounting Plate
by
tightening provided
Tamperproof Screws
.
9.
Refractor
should be tightly seated against
Mounting
Plate Gasket.
Mounting
Plate
O-Ring and
1/4-20 Bolt
Tamperproof
Screws
Refractor
Mounting
Plate Gasket
Supply
Wires
Universal
Mounting Bar
Bar Screw
Ground Screw
Bar Screw
EZ Hang Hook
