Use
Filter
Before you switch on the appliance, the anti-scale filter cassette shall be rinsed as
follows:
•
Remove the water tank (A) by lifting it up from the master unit (E). Lift the anti-
scale filter cassette (B) from the vapour chamber.
•
Before you use the appliance for the first time, rinse the anti-scale filter cassette
(B) thoroughly under running water to remove powder residues from the yellow
water softening balls
Filling of water
•
Position the air humidifier on an even surface, and
note that the air humidifier
should not be positioned on wooden surfaces or similar sensible surfaces,
as they may be damaged due to humidity.
Lift the water tank (A) off the
master unit (E).
•
Turn the water tank upside down and remove the lid. Fill up the water tank with
clean tap water or distilled water (5-40°C). Change the water once a week.
•
Remount the lid on the water tank. Wipe the outside of the water tank with a
dry cloth.
•
Remount the anti-scale filter cassette (B) in the vapour chamber and lower the
water tank. A gurgling sound and water bubbles will emerge from the tank
once correctly positioned in the master unit. The water in the water tank shall
pass through the anti-scale filter cassette to be cleaned and softened, which
takes about 2-5 minutes. When it stops bubbling, the water level in the vapour
chamber is sufficient to generate vapour.
•
Only lift the water tank for filling of water or if the appliance needs cleaning,
since the water level in the vapour chamber might be too high.
How to start the appliance
•
Plug and you will hear two beeps. The appliance is now in the standby position.
•
Start the appliance by pressing the on/off switch (1). The appliance will now
start in the standard position: medium air humidification capacity, activated
illumination in the vapour chamber and without timer setting.
Illumination
Press the illumination button (4) to switch on and off the illumination of the vapour
chamber.
Adjust the vapour temperature
Press the ”cooler/warmer” button (3) to switch between warm and cold vapour. The
indicator (2) in question will go on when activated.
Air humidity level and timer
•
Press the SET button (8) to change from air humidity setting to timer setting and
vice versa. The chosen alternative will be displayed (5, 6) as an indication. Set the
air humidity level or the timer, respectively, by pressing the + (9) or the – (7)
button.
32
6162_ES_0512.indd 32
2012-05-10 10:28:03
