Page 8 of 43
Quick Start Guide
•
Ensure you meet the minimum clearances and recommended installation
locations as outlined in the manual.
•
All accessories (drain barbs, rubber feet and barrel unions) and the
installation manual is contained in a plastic bag inside the packaging of your
heat pump
Pre-Installation
1.
Install the supplied rubber anti-vibration feet under the unit.
2.
Position the heater on a level pad in the desired location on the pool water return line (as shown
in the example image below).
3.
Install the supplied condensation barb(s) to the underside of the unit and direct the condensation
to an appropriate drainage point. The unit must sit level to allow condensation to drain correctly.
The schematic diagram is for reference only. Please check the water inlet/outlet label on the heat pump while plumbing the unit.
Plumbing Installation
PLEASE NOTE:
The supplied fittings accept standard 40mm PVC pressure pipe.
1.
Attach the supplied barrel unions to the inlet and outlet (hand tighten). Use plumbing tape on
the thread and ensure the O-rings are installed and lubricated with a silicone-based grease.
2.
Install a 3-way valve at the cold-water
inlet and create a bypass by connecting a “T” piece to the
heated line. This will allow for the adjustment of water flow to the unit.
3.
Make the plumbing connections and brace pipework where necessary to prevent lateral strain
being applied to the unions. This will aid in preventing future leaks.
Summary of Contents for RAPID PRO RP14
